Товар добавлен в корзину

Moscow (499) 709-71-69
Saint-Petersburg (812) 458-04-28


Fire-resistant polyurethane foam

Fire-resistant polyurethane foam

432 руб./шт.

Товар добавлен



Foam output 45 L.
Use t° from +5°С to +35°C
Color red
Fire-resistance EI 240
Thermal resistance (short-term) from -40°С to +130°С
Thermal resistance (long-term) from -40°С to +90°С
Manufacturer country Russia



Using foam "OGNEZA" allowed in the winter, at a temperature no lower than + 5 ° C, while the temperature of the cylinder should also be at least + 18 ° C and a relative humidity of at least 60%. For optimum foam expansion and better adhesion surface must be moisture.

Permitted short-term (2-3 weeks) to store and transport assembly foam at low temperatures: -35 ° C

Foam stand 2-cycle of freeze-defreeze (up to 90 days).


Application area:

  • To create a fire-retardant and smoke Isolate connections between walls, ceilings and floors;
  • For the installation of doors and windows, fixing of wall panels, roof tiles, insulation;
  • To fill the voids, sealing the through holes left after the dismantling of pipelines and other communications.
  • For thermal insulation of water and sewerage systems, central heating.
  • Excellent adhesion to many construction materials, except for Teflon, polyethylene and silicone surfaces.


  • Output up to 45 liters
  • In the cylinder 935 g
  • Fire resistance 240 minutes
  • Excellent adhesion to concrete
  • The low secondary expansion
  • High thermal insulation properties
  • High sound insulation properties
  • Excellent filling capacity
  • The generated foam has a high density and fine-meshed structure.

Packaging, storage, transport and fire-resistant foam Warranty


Foam takes its fire-retardant properties after 14days after curing. Application temperature from + 5 ° C to +35 ° C. bulb temperature of +18 ° C to + 25 ° C. The best conditions for the application of product by 20 +/- 3 ° C, humidity not less than 60%. Surface Drying Time 10 - 16 minutes. Cured foam can be machined and painted 40 minutes after completion of the work at an ambient temperature of + 23 ° C and 50% relative humidity.

After complete curing (24 hours), the foam must be protected from UV rays.

SAFETY INSTRUCTIONS: Avoid contact with the foam skin and eyes. Work gloves, safety glasses and work clothes. After contact with the foam in your eyes, immediately rinse them with water and seek medical attention, showing the label. When the foam gets on your skin, it can be carefully! Rinse with solvent-based cleaner or acetone foam then wash with soap and water. Ensure adequate ventilation. In areas with poor ventilation working in a respirator for protection against aerosols. Keep out of the reach of children! ATTENTION! The container is under pressure. Protect from direct sunlight and avoid heating the balloon over +50 ° C. DO NOT break the bottle tightness with sealing foam, disassemble empty balloon. Highly Flammable!

In workplaces  do not smoke or use open fire, do not spray foam near hot objects.

Permitted short-term (2-3 weeks) to transport the assembly foam at low temperatures: up to -35 ° C. Number of cycles "freeze-thaw" to the final follow-up shall not exceed 2 times.